Is this removable?

[Goliat6288]

I was wondering if this is removable without breaking it or goin through inside the fender?

[millyowner]

It's held in with a spring clip. Slide it towards the rear of the car and pull the side facing the front toward you and it should pop right out.

[jutu]

I don't think that it is. I know that for the 02's the rear reflectors require screws from the inside of the bumper. If this is similar then it will have to be screwed in from the inside.

[jutu]

Forget what I said then.

[Goliat6288]

ok kol.... Has any one thought about getting that piece made clear? i've read that people have tried to put in the protege ones but they are too small for the whole.

[SteveSter]

ChiTown has his clear, not sure which car they were from though. I think they came off of a celica.

[Goliat6288]

ChiTown has his clear, not sure which car they were from though. I think they came off of a celica.[/b]

yea i say that thread but i think he ended up saying they were still too small to fit the whole.

I was thinking of getting them made clear... would anybody be interested?

[ChitownMillenia]

this is a pic i took when fitting them, there is a piece of clear tape holding them on.

yes, they are from a celica and yes they fit. modding the celica lens and attaching it from inside the fender is a must however. kinda a pita.

[Goliat6288]

this is a pic i took when fitting them, there is a piece of clear tape holding them on.

yes, they are from a celica and yes they fit. modding the celica lens and attaching it from inside the fender is a must however. kinda a pita.[/b]

oooo... kol. would you mind telling me in what way u modded the celica ones to fit the milly?

[ChitownMillenia]

oooo... kol. would you mind telling me in what way u modded the celica ones to fit the milly?[/b]

i had to dremmel/shave down some plastic on the back of the lenses. I had to remove the screws that came on the back of them with longer ones. and i also cut the rubber seal down from the oem lens and epoxyed it to the new ones so they would fit tight and flush. from inside the fender i had to use huge washers with a small hole in the middle and a nut to fasten them to the car with pressure. hard to visualize but once you get the oem lens off and look at the hole n the fender you will see what i'm talking about.