Tranny misterious problem

[LucasX9]

Hi everyone

I own Mazda Millenia with 2.5l engine and I had problem with tranny.When I shift to R car kicks forward and in D position car goes on two speed only.The hold light is flashing.So i get diagnostic and get code P0705,then i erase codes and tranny works normally no flashing Hold light,but after few kilometers the Hold light start flashing again and when shifting to next gear rpm raise about 700-1000 and then shift,but tranny works good.Then i stoped and turn off engine,when i started again the Hold light doesnt flashing and tranny works normally but after few kilometers Hold light start flashing again.

Sorry if i wrote something wrong im not good at english

[Kutcht1]

Hmmmm, that P0705 code is telling you your problem. Quit erasing it and thinking it will go away or fix itself. The flashing hold is a transmission problem, get it fixed.
TomK

[imaddicted2u]

I think the answer is in this thread:
P0705 range sensor code??

[LucasX9]

but range sensor is new,and hold still start flashing after few kilometers

[LucasX9]

and i forgot about second problem a can startup engine in the R,D,S,L position.Not only in P position

[imaddicted2u]

Originally Posted by LucasX9

and i forgot about second problem a can startup engine in the R,D,S,L position.Not only in P position

If the range sensor is new, it is defective or the old one was not defective and you have a wiring problem. It could also be caused by a defective PCM.
When the range sensor was installed, was it calibrated?
You should only be able to start the engine in P and N.

[LucasX9]

as i say i can start in every position,and the switch was probably not calibrate.How can i calibrate the switch or where i should find wiring problem?

[imaddicted2u]

Hope this helps