Relacing ball joints

[Mazda BungiBug]

Hi Guys
First time poster here. I'm trying to replace the ball joints on my 1999 b3000 4x4 truck. The problem I'm running into is the cv joint/axle. I can't seem to figure out how to get it out. It appears to have some clips around it inside of hub. I don't know if it has to be pounded through with a rubber mallet to pop clips or what. I was hoping it had a nut holding it on, but no such luck. Could I remove tie rod end to get the clearance I need to remove/installl new lower ball joint? Then re-install the current tie rod ? I included some pics . Any help would be much appreciated. Thanks

[Tyranitar]

You need snap ring pliers. Get a good service manual, like a Haynes or Chiltons, it gives you the step by step instructions, and usually tells you what kind of special tools you may need.